全自动上料搅拌机是特殊的重型卡车,当混合燃料箱时,负载能力大并且道路条件变得复杂。由于惯性离心力的增加,对全自动上料搅拌机系统的制动系统提出了很高的要求。制动系统对于混合器系统非常重要,但是确定混合器的安全性时首先要考虑的是轿厢的制动距离和制动器的热降解。
Automatic feeding mixer is a special heavy truck, when mixing fuel tank, the load capacity is large and the road conditions become complex. Due to the increase of inertial centrifugal force, the braking system of automatic feeding mixer system has a high demand. The braking system is very important for the mixer system, but when determining the safety of the mixer, the first thing to consider is the braking distance of the car and the thermal degradation of the brake.
如果卡车的制动系统出现问题,驾驶员和乘客也有危险。因此,踩踏或踩踏制动器时,请务必小心。
If there is a problem with the truck's braking system, the driver and passengers are also at risk. Therefore, be careful when applying or applying the brake.
1.制动时发出异常声音
1. Abnormal sound when braking
踩刹车时,刹车系统会引起强烈的金属摩擦。
When you step on the brake, the brake system will cause strong metal friction.
原因可能是刹车片上的异物或刹车盘生锈。
The cause may be foreign matter on the brake pads or rust on the brake discs.
2.制动踏板的行程变长
2. The stroke of brake pedal becomes longer
刹车变软时,您会看到笔直的白点。
As the brakes soften, you'll see straight white spots.
较长的制动冲程主要是由于空气进入制动系统,缺少制动油,可能的泄漏和制动衬块的严重磨损。
The longer brake stroke is mainly due to air entering the brake system, lack of brake oil, possible leakage and serious wear of brake pads.
3.制动偏差
3. Braking deviation
制动器打滑不太常见,主要反映了在施加制动器时方向盘向一侧弯曲的事实。
Brake slip is less common, mainly reflecting the fact that the steering wheel bends to one side when the brake is applied.
造成这种现象的原因可能是制动衬块偏心磨损和制动分泵出现问题。
This phenomenon may be caused by eccentric wear of brake pad and problems of brake cylinder.
4.刹车越来越难
4. Braking is more and more difficult
许多卡都有增加制动的问题。加强制动器的主要原因是真空助力器故障。刹车不辅助,经常使用刹车。
Many cards have the problem of increasing braking. The main reason for strengthening the brake is the failure of the vacuum booster. The brake is not auxiliary, and the brake is often used.
5.刹车回弹
5. Brake rebound
许多卡伙伴都遇到过这种情况,但是在制动时,会出现一种现象,其中上肢从制动踏板上弹起,主要是由于制动盘表面不平整。垫片和钢环变形。
Many card partners have encountered this situation, but when braking, there will be a phenomenon, in which the upper limb bounces from the brake pedal, mainly due to the uneven surface of the brake disc. The gasket and steel ring are deformed.