自动上料搅拌机目前在混凝土建筑行业比较常见，也是深受大家欢迎的混凝土搅拌器械，自动上料搅拌机的正常长寿命的顺畅使用离不开日常有效的维护，下面让我们一起来看下自动上料搅拌机如何进行有效维护：
At present, the automatic feeding mixer is common in the concrete construction industry and is also a popular concrete mixing equipment. The normal and long-life smooth use of the automatic feeding mixer is inseparable from daily effective maintenance. Let's take a look at how to effectively maintain the automatic feeding mixer:
1、自动上料搅拌机发动前，必须全面进行检查，各部件量正常可靠，螺栓连接是否紧固，操作是否灵活等。
1. Before starting the automatic feeding mixer, a comprehensive inspection must be carried out to ensure that the quantity of each component is normal and reliable, whether the bolt connection is fastened, whether the operation is flexible, etc.
2、各部位润滑点示意要求进行，加油处必须保持干净。
2. The lubrication points of all parts shall be carried out according to the schematic requirements, and the refueling place must be kept clean.
3、液压、气压各系统管路是澡密封牢固，是否有磨损，是否有漏油，漏气等现象应及时检查排除。
3. The pipelines of hydraulic and pneumatic systems shall be sealed firmly, and whether there is wear, oil leakage, air leakage and other phenomena shall be checked and eliminated in time.
4、对液压泵。液压马达，减速河曲等元件，必须遵循产品说明书的要求进行保养。
4. Check the hydraulic pump. Hydraulic motor, deceleration bend and other components must be maintained in accordance with the requirements of the product manual.
5、自动上料搅拌机要定期检查搅拌叶片的磨损情况，作到及时修补。
5. The automatic feeding mixer shall regularly check the wear of mixing blades and repair them in time.
6、托轮的保养：每3个月应定期补加润滑脂一次，搅拌筒托轮表面每天都要注油一次，已避免托轮异常磨损。
6. Maintenance of supporting roller: the lubricating grease shall be added regularly every 3 months, and the surface of the supporting roller of the mixing drum shall be filled with oil once a day to avoid abnormal wear of the supporting roller.
7、供水系的保养：混凝土搅拌车供水方式为气压供水，从底盘储气筒取气，因此应经常检查其气路的密封性，以保证金底盘气路不受影响。
7. Maintenance of water supply system: the water supply mode of concrete mixer truck is pneumatic water supply, and the air is taken from the chassis air reservoir. Therefore, the tightness of its air circuit should be checked frequently to ensure that the chassis air circuit will not be affected.
8、自动上料搅拌机的搅拌筒的保养：每次工作完华后，搅拌筒内必须有粗石子加清水洗干净，按出料方法操作，把筒内积水排尽，同时也要对搅拌筒外表及底座周围的水泥残渣进行冲洗，正确处理和保养能延长搅拌筒的使用寿命。
8. Maintenance of mixing drum of automatic feeding mixer: after each work, there must be coarse stones in the mixing drum and washed with clean water. Operate according to the discharging method to drain the accumulated water in the drum. At the same time, wash the cement Residue around the surface of the mixing drum and the base. Correct treatment and maintenance can prolong the service life of the mixing drum.
9、人进入搅拌筒检修时，发动机必须熄火，并将启动钥匙由进入搅拌筒检修人员保管，以确保人身安全。
9. When people enter the mixing drum for maintenance, the engine must be turned off, and the start key shall be kept by the maintenance personnel entering the mixing drum to ensure personal safety.
10、下班时，搅拌筒。进出料装置和车身外表要用水洗干净，防止混凝土结在筒壁和叶片等地方上，如发现局部有混凝土凝结硬块时，要尽快清除，但不得损坏机件。
10. When off duty, the mixing drum. The appearance of the feeding and discharging device and the vehicle body shall be washed with water to prevent the concrete from binding on the cylinder wall, blades and other places. If local concrete congealing hard blocks are found, they shall be removed as soon as possible, but the parts shall not be damaged.
11、冬季混凝土搅拌车不用时，应放净水箱内及清洗管路的积水。
11. When the concrete mixer is not used in winter, the accumulated water in the water tank and the cleaning pipeline shall be drained.
The above is the automatic feeding mixer http://www.shanqijituan.com/ Thank you for your browsing. If you want to know other product information, please log in to our official website. Automatic mixer automatic feeding mixer
山汽官方微信
2022-12-23
首页
产品
电话
置顶