全自动上料搅拌车液压油如何更环保？_行业新闻_新闻资讯_全自动上料搅拌机车

新闻资讯

行业新闻公司新闻

热点推荐

自动上料搅拌机配件是由哪两部分组成的？

2022-12-23

修路有哪些不错的机械设备？先说说这个小型搅拌车

2022-12-19

自上料搅拌车操作须知的五项重要内容

2022-12-16

自上料拌和车的特征有哪些？

2022-12-12

自动上料搅拌车能解决哪些施工难题？

2022-12-02

混凝土搅拌车的刹车片要怎样挑选合格

2022-11-14

关于山汽

联系人：刘老师

电话：400-879-1999

公司：山东山汽工程机械（集团）有限公司

地址：山东省莱州市206国道与308省道交叉口东南50米

全自动上料搅拌车液压油如何更环保？

所属分类：行业新闻发布时间：2022-03-01 来源：http://www.shanqijituan.com 浏览量：0

接下来的文章主要和大家分享一下关于：小型混凝土搅拌车液压油如何更环保？

The next article mainly shares with you about: how can the hydraulic oil of small concrete mixer be more environmentally friendly?

1.混凝土搅拌车全部展开各支腿油缸，包括摆动、伸缩（伸出和缩进比喻在一定限度内的变通）、垂直油缸等；臂架因场地、时效等因素局限，仅展开（全展）大臂油缸，其余臂架油缸收缩到位；活塞杆巡查：检查泵送油缸活塞杆是否有拉伤迹象，如有则更换；检查油箱各油口连接处，是否有漏油、开裂等现象。

1. The concrete mixer truck shall fully expand each outrigger oil cylinder, including swing, expansion (extension and retraction are compared with the flexibility within a certain limit), vertical oil cylinder, etc; Due to the limitation of site, time and other factors, only the boom oil cylinder is expanded (fully extended), and the other boom oil cylinders are retracted in place; Piston rod inspection: check whether the piston rod of pumping oil cylinder has signs of strain, and replace it if any; Check whether there is oil leakage, cracking and other phenomena at the connection of each oil port of the oil tank.

2.排油工作

2. Oil drainage

将小型混凝土搅拌车的车泵送油缸液压油排除，拆除砼活塞和泵送油缸无杆或链接阀块；进行闭式系统排油和开式系统排油，排除油缸油杆腔油液和油箱液压油。

Drain the hydraulic oil from the pumping oil cylinder of the small concrete mixer, and remove the concrete piston and pumping oil cylinder without rod or link valve block; Drain the oil of closed system and open system, and drain the oil in the oil cylinder rod cavity and the hydraulic oil in the oil tank.

3.进行小型泵车油箱清洗，拆掉油箱底部防水隔板，用柴油或煤油清洗液压油箱，用海绵吸出多余的油，然后用面团把油箱内的参与杂质粘干净。

3. Clean the oil tank of small pump truck, remove the waterproof diaphragm at the bottom of the oil tank, clean the hydraulic oil tank with diesel or kerosene, suck out the excess oil with sponge, and then paste the impurities in the oil tank with dough.

4.对元件进行清洗，液压阀，阀块，油箱防水隔板，过滤器壳体，多路阀清洗。

4. Clean the components, hydraulic valve, valve block, oil tank waterproof diaphragm, filter shell and multi-way valve.

5.加注液压油

5. Fill hydraulic oil

6.泵送、搅拌液压系统排油

6. Oil drainage of pumping and mixing hydraulic system

7.分配系统排油

7. Oil drainage of distribution system

8.泄油管路排油。为保证油箱油液顺利冲洗泄油管路，所拆除泄油管路接头处低于油箱液面。

8. Drain the oil from the oil drain pipeline. In order to ensure that the oil in the oil tank can flush the oil drain pipeline smoothly, the joint of the removed oil drain pipeline is lower than the liquid level of the oil tank.

9.混凝土搅拌车的车泵泵车臂架液压系统排油。因在排油前大臂油缸伸展到位，其余油缸收缩到位，故所有臂架油缸只有一腔充满油液；另一腔因油缸伸展、收缩到位，所容纳油液体积很小，可以忽略。

9. The hydraulic system of the boom of the truck pump truck of the concrete mixer is drained. Because the boom oil cylinder is extended in place and the other oil cylinders are retracted in place before oil drainage, only one chamber of all boom oil cylinders is filled with oil; The volume of oil contained in the other chamber is very small and can be ignored due to the extension and contraction of the oil cylinder in place.

以上就是今天带给大家的知识，全自动上料搅拌车专注行业多年，为用户不断的提供有价值的内容，更多内容请继续关注我们：http://www.shanqijituan.com/

The above is the knowledge brought to you today. The automatic feeding mixer has focused on the industry for many years and continuously provides users with valuable content. Please continue to pay attention to us for more content: http://www.shanqijituan.com/

上一页：一款好的搅拌车应该具备的机械素质有哪些？下一页：为什么使用自动上料搅拌机贮罐后需要清洗维护？