山东山汽工程机械(集团)有限公司
热线电话:400-879-1999 山汽官方微信
郑重声明 购机 售后
在线询价
热线电话:400-879-1999
您现在所在的位置: 首页> 新闻资讯 > 公司新闻

自上料搅拌机制动系统的重要性

所属分类:公司新闻 发布时间:2022-03-09 来源:http://www.shanqijituan.com 浏览量:0

全自动上料搅拌机是特殊的重型车,当混合燃料箱时,负载能力大并且道路条件变得复杂。由于惯性离心力的增加,对全自动上料搅拌机系统的制动系统提出了很高的要求。制动系统对于混合器系统非常重要,但是确定混合器时首先要考虑的是轿厢的制动距离和制动器的热降解。如果卡车的制动系统出现问题,驾驶员和乘客也有危险。因此,踩踏或踩踏制动器时,请务必小心。
Full automatic loading mixer is a special heavy-duty vehicle. When mixing fuel tanks, the load capacity is large and the road conditions become complex. Due to the increase of inertial centrifugal force, high requirements are put forward for the braking system of full-automatic feeding mixer system. The braking system is very important for the mixer system, but when determining the mixer, the first consideration is the braking distance of the lift car and the thermal degradation of the brake. If there is a problem with the braking system of the truck, the driver and passengers are also at risk. Therefore, be careful when applying or applying the brake.
1.制动时发出异常声音;踩刹车时,刹车系统会引起强烈的金属摩擦。原因可能是刹车片上的异物或刹车盘生锈。
1. Abnormal sound during braking; When stepping on the brake, the brake system will cause strong metal friction. The reason may be foreign matters on the brake pad or rust on the brake disc.
2.制动踏板的行程变长;刹车变软时,您会看到笔直的白点。较长的制动冲程主要是由于空气进入制动系统,缺少制动油,可能的泄漏和制动衬块的严重磨损。
2. The stroke of the brake pedal becomes longer; When the brakes soften, you will see straight white spots. The longer braking stroke is mainly due to air entering the braking system, lack of brake oil, possible leakage and serious wear of brake pads.
3.制动偏差;制动器打滑不太常见,主要反映了在施加制动器时方向盘向一侧弯曲的事实。造成这种现象的原因可能是制动衬块偏心磨损和制动分泵出现问题。
3. Braking deviation; Brake slip is less common and mainly reflects the fact that the steering wheel bends to one side when the brake is applied. This phenomenon may be caused by eccentric wear of brake pads and problems of brake wheel cylinder.
4.刹车越来越难;许多卡都有增加制动的问题。加强制动器的主要原因是真空助力器故障。刹车不辅助,经常使用刹车。
4. Braking becomes more and more difficult; Many cards have the problem of increasing braking. The main reason for strengthening the brake is the failure of the vacuum booster. The brake is not assisted, and the brake is often used.
5.刹车回弹;许多卡伙伴都遇到过这种情况,但是在制动时,会出现一种现象,其中上肢从制动踏板上弹起,主要是由于制动盘表面不平整。垫片和钢环变形。
5. Brake rebound; Many card partners have encountered this situation, but when braking, there will be a phenomenon in which the upper limb bounces from the brake pedal, mainly due to the uneven surface of the brake disc. The gasket and steel ring are deformed.
以上就是为大家介绍的有关全自动上料搅拌机的详细介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务http://www.shanqijituan.com/
The above is a detailed introduction to the automatic feeding mixer. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://www.shanqijituan.com/

 

首页 产品 电话 置顶