山东山汽工程机械(集团)有限公司
热线电话:400-879-1999 山汽微信
郑重声明 购机 售后
在线询价
热线电话:400-879-1999
您现在所在的位置: 首页> 新闻资讯 > 公司新闻

自动上料搅拌车手工擦洗注意什么?

所属分类:公司新闻 发布时间:2021-02-10 来源:http://www.shanqijituan.com 浏览量:0

用于手动擦洗的自动上料搅拌车的主要材料是:清水,工具是桶,软刷,毛巾和干毛巾。
The main materials of automatic feeding mixer used for manual scrubbing are: clean water, tools are buckets, soft brushes, towels and dry towels.
1.将毛巾浸入水中,然后从屋顶向下慢慢浸湿整个身体。
1. Immerse the towel in the water, and then slowly wet the whole body from the roof down.
2.用湿毛巾从汽车顶部擦拭测试,擦去灰尘,然后从顶部到底部逐渐擦拭车窗和护罩上的灰尘。擦去污垢。毛巾不能用沙子擦拭,否则会在胶片表面和玻璃上刮擦或刮擦。
2. Wipe the test with a wet towel from the top of the car to remove the dust, and then gradually wipe the dust on the window and shield from the top to the bottom. Wipe off the dirt. Towel can not be wiped with sand, otherwise it will scratch or scratch on the film surface and glass.
3.如果有很多污垢,可以先用软毛刷刷一下,然后用水冲洗,然后再用毛巾擦洗。
3. If there is a lot of dirt, you can brush it with a soft brush first, then rinse it with water, and then scrub it with a towel.
全自动上料搅拌机
4.再次擦洗车身后,请仔细检查是否有残留的灰尘。如果是这样,请立即再次擦拭,直到将其清洁。
4. After cleaning the car again, please carefully check whether there is residual dust. If so, wipe the tip again immediately until it is clean.
5.使用干净的干毛巾以上述方式再次擦拭车身,直到擦拭干净为止,不得留下任何污垢和水印。
5. Use a clean dry towel to wipe the car body again in the above way until it is clean, without leaving any dirt and watermark.
自动上料搅拌车手工擦洗问题就是这样,希望对你有帮助。
Automatic feeding mixer hand scrubbing problem is like this, I hope to help you.
以上的精彩内容来自: 全自动上料搅拌机详细的内容请点击进入我们的网站进行查询对接:http://www.shanqijituan.com
The above wonderful content comes from: full automatic feeding mixer. For details, please click to enter our website for query and docking http://www.shanqijituan.com

 

首页 产品 电话 置顶