山东山汽工程机械(集团)有限公司
热线电话:400-879-1999 山汽微信
郑重声明 购机 售后
在线询价
热线电话:400-879-1999
您现在所在的位置: 首页> 新闻资讯 > 行业新闻

混凝土搅拌车发动机外部清洗应该注意哪些?

所属分类:行业新闻 发布时间:2020-12-04 来源:http://www.shanqijituan.com 浏览量:0

步骤一:用塑料薄膜将搅拌车分电器遮盖起来,用半湿毛巾压住薄膜,此举可以防止高压水冲进分电器,导致搅拌车故障。
Step 1: first cover the distributor of the mixer with plastic film, and press the film with a semi wet towel. This can prevent high-pressure water from rushing into the distributor and causing the mixer to malfunction.
步骤二:使用高压水枪由搅拌车发动机侧面按从上到下的顺序将引擎室内侧及搅拌车发动机外表的附着类污物冲净。
Step 2: use a high-pressure water gun to clean the attached dirt on the inside of the engine and the outside of the mixer engine from top to bottom.
搅拌车小知识:混凝土搅拌车发动机外部清洗的正确打开方式
Mixer knowledge: the right way to open the external cleaning of concrete mixer engine
步骤三:将发动机外部清洁剂均匀喷洒在浸湿后的发动机及引擎室四周,等待三到五分钟,用毛刷仔细清洗引擎室。
Step 3: spray the engine external cleaner evenly on the wet engine and around the engine room, wait for three to five minutes, and carefully clean the engine room with a brush.
步骤四:直接用高压水枪快速冲洗污渍。
Step 4: wash the stains with high pressure water gun.
全自动上料搅拌车
搅拌车小知识:混凝土搅拌车发动机外部清洗的正确打开方式
Mixer knowledge: the right way to open the external cleaning of concrete mixer engine
步骤五:重复步骤三和步骤四,直发动机表面清洗干净
Step 5: repeat step 3 and step 4 until the engine surface is cleaned
步骤六:搅拌车发动机冲洗干净后,用半湿毛巾擦干,擦不到的地方用风干机吸干,等待风干。
Step 6: after the mixer engine is washed clean, dry it with a semi wet towel, dry the area that can't be wiped with an air dryer, and finally wait for air drying.
步骤七:用塑料橡胶保护剂给引擎室内的塑料橡胶部件上光,然后给金属部件镀膜。
Step 7: polish the plastic rubber parts in the engine room with plastic rubber protector, and then coat the metal parts.
步骤八:所有步骤完成后,用干净的无纺抛光巾检验搅拌车发动机和引擎室内侧。
Step 8: after all steps are completed, inspect the mixer engine and the inside of the engine compartment with a clean non-woven polishing towel.

 

首页 产品 电话 置顶